Mood DIY: Retro Wrap Shirt

Posted on April 8, 2016 by Lee Norris

I made a cute, retro wrap dress recently, based off Butterick 4790, and was amazed by how simple it was. Since it was little more than two rectangle panels, with a hole cut out for the neckline, it was complete in an afternoon. Feeling adventurous, I decided to try creating a similar look with a crop top I was making for a coworker.

DSC_0062a

Even fully lined, the shirt only took 1 yard of cotton poplin, and drafting a pattern for it was incredibly simple (you can see it below). The main panel was 54"x36" and I also cut two 36"x5" strips, which would become the ties.

307649-f

I cut two of the main panel, folded them in half and cut a hole for the head. In the photo below, what would become the back of the shirt is at the top. As you can see, the cut levels out toward the top, so the neckline doesn't plunge in the back.

DSC_0032

Instead of keeping the super wide, retro sleeves, I cut a long triangle off the sides of each panel, like you see here. This brought the shoulders of the shirt in just a few inches.

DSC_0036

The next step was sewing the panels, right sides together. Before finishing, I added a 1/2 yard of ribbon to the edges of the front section of the panel. When putting on the finished shirt, the ribbons tie behind you, before the fabric ties wrap around from the back to tie over the front panel. Don't sew the last 2.5" on the ends that will become the back of the shirt.

DSC_0037

Before adding the fabric ties, the neckline needs to be sewn, which is the trickiest part of construction. Without turning the shirt completely inside out, the right sides still need to be stitched together. This can be done by sewing one half of the neckline through the opening at the bottom of the front panel, like below; then doing the same through the back panel.

DSC_0039a

After the neckline is sewn, be sure to clip the seam allowance. Skipping this step an make curves wrinkly and strained. Clipping allows the fabric to spread out, making your seams lie smooth.

neckline

Pin your fabric tie strips to the 2.5" section you left open at the bottom of the back panel before.

DSC_0044

Fold the strips in half, and sew from the shirt panel, to the end of the strap. At the end, I sewed a 45 degree angle, instead of making the straps boring rectangles.

DSC_0049

Flip the ties right side out, and close the front and back panels by folding and topstitching the ends, like below.

DSC_0045

 Pair with some cute leggings or a simple midi skirt, and you've got a DIY vintage-inspired look perfect for spring!

DSC_0074 DSC_0064 DSC_0071 DSC_0068

 

Mood DIY: Retro Wrap Shirt - Mood Sewciety
FREE SHIPPING DOMESTIC ORDERS $100+
Home DIY Mood DIY: Retro Wrap Shirt